Edit the profile, reversing what needs to be reversed (mine needed none). In RF, choose the new TX - use the Futaba profile to start. I have mine cabled from the Taranis to the Interlink using the buddy box cord from RF. Just set it as the source, leave the "switch" line blank. In the Mixes tab, the above should track: CH1 = I1:Ail Weight(+100%), etc.įor channels 5-8 in mixes, make sure the source is the switch/slider you want to use, with a weight of 100%. ![]() Nope, there will be no more than 4 channels possible here. Make sure under Inputs, I1=A, I2=E, I3=T, I4=R Make sure under Setup for the model, it is set for "slave" mode, and channels 1-8. I followed these instructions which work well: Using 2.2.1 software, both on the TX and Companion.
0 Comments
Leave a Reply. |